What This Oil Filter Wrench Fits

• The oil filter wrench has a very solid construction, which is composed of forged 6061 T5 aluminum.
• This is material is better than cast aluminum, and won’t crack under pressure.
• On top is a high quality black anodized finish, which is designed to prevent corrosion for durability purposes.
• Simplifies the clean-up process after doing an oil change, and it does not chip or peel.

These features make this the best oil filter wrench for Toyota and Lexus.

• Lexus ES
• Lexus GS
• Lexus GX
• Lexus IS
• Lexus LS
• Lexus LX
• Lexus NX
• Lexus RC
• Lexus RX
• Scion tC

• Toyota 4-Runner
• Toyota Avalon
• Toyota Camry
• Toyota FJ Cruiser
• Toyota Highlander
• Toyota Land Cruiser
• Toyota RAV4
• Toyota Sequoia
• Toyota Sienna
• Toyota Tacoma
• Toyota Tundra
• Toyota Venza

Oil filter installation instructions:

• To allow access to the oil filter housing, use a ratchet and 3/8” drive socket extension.
• To remove the cap from the bottom of the filter housing.
• This is done by inserting the socket extension into the cap and turning the ratchet counterclockwise.
• Place the oil drain pan under the filter housing, and thread the plastic nipple, that was included with the replacement oil filter, into the bottom of the oil filter housing.
• Allow oil from the filter housing to drain, and then remove the plastic nipple.
• Put the Motivx Tool oil filter wrench onto the bottom of the oil filter housing.
• The center slot on the side of the oil filter wrench should be aligned over the “wings” on the filter housing.
• Insert the 3/8″ drive socket extension into the square opening in the bottom of the filter wrench, and use a ratchet to remove the oil filter housing by turning it counterclockwise.
• Thread the oil filter housing into the same location that the plastic version was removed from.
• Put the Motivx Tool oil filter wrench onto the bottom of the oil filter housing.
• Insert the 3/8″ drive socket extension into the square opening in the bottom of the filter wrench, and use a ratchet to install the oil filter housing by turning it clockwise.
• Put the small O-ring that was included with the replacement oil filter, into the bottom of the oil filter base.
• Tighten the oil cap, and then use a ratchet and 3/8” drive socket extension to install it into the oil filter housing by turning it clockwise.
  Start the vehicle and check for leaks.

Source: https://www.motivxtools.com/products/toyota-2-5l-5-7l-oil-filter-wrench